Re: l4ka::pistachio boot problem

Hi Jan,

This is exactly what I did to build l4ka-pistachio and marzipan with
afterburner. I downloaded afterburner and tried building it. It
internally downloaded everything into a single build dir (including
linux-2.6.9 and xen). I used the default configs (make menuconfig in
the build dir) except I'm using VGA as opposed to serial in the
default configs. Did I miss anything important? Any thoughts about the
above problem?

Thanks,
Ashish

On Feb 12, 2008 11:36 AM, Jan Stoess <[email protected]> wrote:
> Hello Ashish,
>
> We do not longer use the CVS repositories anymore. The web page has been
> stale for some rather long time. We have switched to using mercurial for the
> pre-virtualization and marzipan code. They are now all contained in a single
> repository called afterburner. I've updated the web pages appropriately. So
> I'd suggest you to check out the afterburner mercurial module and take it
> from there. The module contains a sample config for P4 boxes automatically
> copied to the build directory initially. You can try compiling the
> afterburner with this config or adopt it to your needs. Let me know if you
> run into problems again.
>
> Regards,
> -Jan
>
> --
> Jan Stoess
> System Architecture Group
> University of Karlsruhe
> Phone: +49 (721) 608-4056
> Fax: +49 (721) 608-7664
> eMail: [email protected]
>
>