Re: Native L4 network application

The tex file is building and I can log in to the client Linux

Thanks
David



----- Original Message ----
From: Jan Stoess <[email protected]>
To: David Silcott <[email protected]>; "[email protected]" <[email protected]>
Sent: Mon, May 17, 2010 2:29:31 PM
Subject: RE: Native L4 network application

Hi David,
> I have trawled through the afterburner directory and found
> afterburner/Documentation/L4Ka-Afterburner.tex
> which seems a bit dated but potentially informative. This however
> references some files which cannot be found anywhere within the
> afterburner folder nor was I able to find  a full pdf version of this document .
> If anyone could point me to where I can get all the required files to compile
> this tex file or point me to a full pdf version that will be very helpful.
I just committed the missing files in Documentation/figures. The tex file  should build now.

> Furthermore, I am able to compile and run a dd/os but I don't know the
> credentials to log into the system, is this documented some where?

Are you referring to the client linux ramdisk downloadable from i30www? Should be "root/mlx". The DD/OS ramdisk itself doesn't allow ssh by default, only the client. I recently changed the DD/OS ramdisk to be based on busybox, which should give you a login on the serial debug port. Resourcemon multiplexes guest consoles, you can switch them via <ESC-n>, see l4ka-resourcemon/console.cc. 

Best,
-Jan


--
Dr. Jan Stoess
KIT/UKa System Architecture Group
Phone: +49 (721) 608 4056
Fax: +49 (721) 608 7664
http://os.ibds.kit.edu/stoess