Re: [mh] Reading ALDB of Keypadlincs

So whenever I've had to swap a KPL or PLM out this is the only way I've
gotten them to work.

This kind of depends on if you're replacing a KPL or adding a new one, but
in any case these steps should work:

Remove (comment out) references to the KPL in your insteon mht and reload
PLM Global->force scan all device link tables
PLM Global->delete orphan Links

Now add the device back into the mht and reload:

Factory reset the KPL (Pull the tab, push and hold until beeping stops),
this step seems very important in my testing.
(KPL base device)->Link to Interface (which will trigger a scan)
PLM Global->Sync all links
(KPL base)->sync intradevice links


See if that helps.

On Mon, Aug 30, 2021 at 7:48 PM H Plato <[email protected]> wrote:

> Hello,
>
>   Does anyone else have a challenge scanning the link tables of
> keypadlincs? I see in the logs that it starts to scan, and reads a few of
> the entries, but then just stops. I have to try dozens of times to hope
> that one of them works. Just wondering if there any any suggestions or
> ideas — I picked up another keypadlinc, and trying to add some of the
> buttons to scenes, but it’s been all afternoon and haven’t been successful
> to scan a link table on this device, which is required before I can sync
> links.
>
> ________________________________________________________
> To unsubscribe from this list, go to:
> https://lists.sourceforge.net/lists/listinfo/misterhouse-users
>
>

________________________________________________________
To unsubscribe from this list, go to: https://lists.sourceforge.net/lists/listinfo/misterhouse-users