Re: [mh] Reading ALDB of Keypadlincs

OK, after a bunch of inconsistent results, I’m going to take your suggestions. I think the KPL’s can’t be scanned due to the amount of links they’ve acquired. After about 30 tries, I managed to scan it, but it went through like 20 addresses. A factory reset on both KPLs can’t hurt at this point.

Just one question, the ‘comment out reference’ to that’s commenting out the KPL object line in the items.mht file. Why that line? I’d have to go through and comment out a bunch of statements in other code files, as well as to remove those KPLs from all the SCENE_BUILD statements in items.mht. I’m ok with doing this to get a successful outcome, but just curious why it’s there.

> On Sep 2, 2021, at 7:19 AM, Spencer Ryan <[email protected]> wrote:
> 
> So whenever I've had to swap a KPL or PLM out this is the only way I've gotten them to work.
> 
> This kind of depends on if you're replacing a KPL or adding a new one, but in any case these steps should work:
> 
> Remove (comment out) references to the KPL in your insteon mht and reload
> PLM Global->force scan all device link tables
> PLM Global->delete orphan Links
> 
> Now add the device back into the mht and reload:
> 
> Factory reset the KPL (Pull the tab, push and hold until beeping stops), this step seems very important in my testing.
> (KPL base device)->Link to Interface (which will trigger a scan)
> PLM Global->Sync all links
> (KPL base)->sync intradevice links
> 
> 
> See if that helps. 
> 
> On Mon, Aug 30, 2021 at 7:48 PM H Plato <[email protected] <mailto:[email protected]>> wrote:
> Hello,
> 
>   Does anyone else have a challenge scanning the link tables of keypadlincs? I see in the logs that it starts to scan, and reads a few of the entries, but then just stops. I have to try dozens of times to hope that one of them works. Just wondering if there any any suggestions or ideas — I picked up another keypadlinc, and trying to add some of the buttons to scenes, but it’s been all afternoon and haven’t been successful to scan a link table on this device, which is required before I can sync links.
> 
> ________________________________________________________
> To unsubscribe from this list, go to: https://lists.sourceforge.net/lists/listinfo/misterhouse-users <https://lists.sourceforge.net/lists/listinfo/misterhouse-users>
>

________________________________________________________
To unsubscribe from this list, go to: https://lists.sourceforge.net/lists/listinfo/misterhouse-users