Re: [protege-user] Saving ontographs constructed with instances and classes

I don't use OntoGraph much but a couple of thoughts:
1) I didn't see what the error message was (but I can see there is one by
the red triangle in the lower right corner). You might want to do
Window>Show Log (about 3rd item from the bottom). That will show the log
and the error message and you can send a screen shot of that. That will
help debug the problem.

2) I notice you didn't run the reasoner in any of those screen captures. I
doubt that will fix the problem but just wanted to point out make sure you
do that. Especially for new users it is a good idea to run the reasoner
often. I recommend after every change that could have some impact on the
logic. If you have one error the reasoner can usually point you right to it
(sometimes the messages are a bit cryptic if you aren't used to reading
them but people on this list can help with that) but if you have say 5 or
more errors the reasoner often can't give much more info than that the
ontology is inconsistent.

Michael
https://www.michaeldebellis.com/blog

On Thu, Feb 6, 2025 at 6:38 AM Jean-Louis Janin <[email protected]>
wrote:

> Hello again,
>
> Some screen shots attached. Why this error message when opening the
> saged file's graph ?
>
> Jean-Louis Janin
>
>
> Le 06/02/2025 à 15:00, Jean-Louis Janin a écrit :
> > Hello,
> >
> > With Desktop version 5.6.4 of Protégé, it is possible to save an
> > ontograph's file constructed on some classes withOntoGraph. Why is it
> > not possible to do the same with an ontogoraph file consructed on a
> > class a and instances of that class ?
> >
> > Jean-Louis Janin_______________________________________________
> protege-user mailing list
> [email protected]
> https://mailman.stanford.edu/mailman/listinfo/protege-user
>

_______________________________________________
protege-user mailing list
[email protected]
https://mailman.stanford.edu/mailman/listinfo/protege-user