Re: BitPim 0.9.13 now available for initial checkout

Python 2.4 gets installed in 
/Library/Frameworks/Python.Framework/Versions/2.4 so

 sudo rm -rf /Library/Frameworks/Python.Framework/Versions/2.4

Open a new terminal window and it should have reset.  Before you do 
that, however, I have been working with Mark Moran on building a 
Universal binary.  Since there is no universal version of 2.3, if you 
want to take that road you are going to have use 2.4.   (Confused yet? 
:)  I have managed to get a working build with python2.3/PPC/10.3.+ and 
of the universal binary (python2.4/PPC+Intel/10.3.9+).  (Although I can 
only vouch for the PPC operation.)

If you have an AIM/.mac account I can sent either to you via iChat.

Sean

Allen Hancock wrote:
>
> On Mar 15, 2007, at 9:56 PM, Sean Burke wrote:
>> Setup for building Bitpim.app on OS X 10.4.9
>> 1) Python.  Use the default python installation.  Check the version
>> with: >python -V.   You should get 2.3.5.  If you get 2.4.x or 2.5.x,
>> then you have probably downloaded one of the precompiled packages from
>> macPython.  Check the site for instructions on how to make 2.3.5 the
>> "Current" version.
>
> alright, i give up. I have looked all over the place for how to roll 
> back to 2.3...
> Has anyone seen these steps?  would hate to clean install, but am 
> willing...
>
>
>
>

-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys-and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV