Re: BitPim 0.9.13 now available for initial checkout

You can use the command python2.3 and it will run the system installed
Python. I have been trying to get BitPim to build on 2.4 and 2.5 but no
dice because of the APSW dependency failing. I will try again tonight on
2.3.

Adit

On Fri, March 16, 2007 10:39, Allen Hancock wrote:
>

> On Mar 15, 2007, at 9:56 PM, Sean Burke wrote:
>
>> Setup for building Bitpim.app on OS X 10.4.9
>> 1) Python.  Use the default python installation.  Check the version
>> with: >python -V.   You should get 2.3.5.  If you get 2.4.x or 2.5.x,
>> then you have probably downloaded one of the precompiled packages from
>> macPython.  Check the site for instructions on how to make 2.3.5 the
>> "Current" version.
>>
>
> alright, i give up. I have looked all over the place for how to roll back
> to 2.3... Has anyone seen these steps?  would hate to clean install, but
> am willing...
>
>
>
>
> -------------------------------------------------------------------------
>  Take Surveys. Earn Cash. Influence the Future of IT
> Join SourceForge.net's Techsay panel and you'll get the chance to share
> your opinions on IT & business topics through brief surveys-and earn cash
> http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
>  _______________________________________________
> BitPim-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/bitpim-devel
>
>



-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys-and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV