Re: BitPim Official Release 1.0.6 Katana Problem

Thank you Stephen, will post if that solves the issue.
 
Don L.

-----Original Message-----
From: [email protected] [mailto:[email protected]]On Behalf Of Stephen Wood
Sent: Tuesday, August 19, 2008 1:53 PM
To: [email protected]
Subject: Re: [BitPim-devel] BitPim Official Release 1.0.6 Katana Problem


I will look into this.

In the meantime, make sure that BitPim is using the same port that DataPilot uses.  I believe that the driver creates two COM ports for this phone and perhaps only the detection of which port to use for the Katana got messed up in 1.06.

Stephen

On Tue, Aug 19, 2008 at 1:03 PM, Don Lewis < [email protected]> wrote:
> Additionally, I have been able to connect and read data from this phone with DataPilot.
>
> Don L.
>
> -----Original Message-----
> From: [email protected]
> [mailto: [email protected]]On Behalf Of Don
> Lewis
> Sent: Tuesday, August 19, 2008 9:39 AM
> To: [email protected]
> Subject: [BitPim-devel] BitPim Official Release 1.0.6 Katana Problem
>
>
> I have a Sanyo Katana SCP-6600.  When trying to read the data from the phone I recieve an error.
>...

-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/

_______________________________________________
BitPim-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bitpim-devel