Re: BitPim and LG VX6100

The access denied message makes me suspect that where it's trying to
write to is marked as read-only or requires administrator privilege.
Have you tried 'run as...'?  Also, in the com port browse window, does
it say that port is active and available for use?

On Sun, 2010-07-11 at 22:28 -0400, Mark Yaworski wrote:
> BitPim works fine with my LG VX8300 (yes, I like OLD phones) but I 
> need to get some stuff off my OOOOLD VX6100.
> 
> The two phones use the same cable and apparently the same driver.
> 
> Plug the phone in and WinXP recognizes that it is there and assigns 
> it a com port.
> 
> VZAccess manager queries the phone and reports it correctly.
> 
> However, I get the following message from BitPim
> 
> COM4: could not open port\\?\COM4 (5,'CreateFile','Access is denied.')
> 
> Any ideas?  If this is out of bounds for support, I guess I'm back to 
> square one.
> 
> Thanks.
> 
> 
> ------------------------------------------------------------------------------
> This SF.net email is sponsored by Sprint
> What will you do first with EVO, the first 4G phone?
> Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first
> _______________________________________________
> BitPim-user mailing list [email protected]
> Unsubscribe or change options at
> https://lists.sourceforge.net/lists/listinfo/bitpim-user
> 
> There are several hundred people on this list.  Please be
> courteous, on topic and follow the instructions before posting
> http://www.bitpim.org/help/support.htm
>

------------------------------------------------------------------------------
This SF.net email is sponsored by Sprint
What will you do first with EVO, the first 4G phone?
Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first

_______________________________________________
BitPim-user mailing list [email protected]
Unsubscribe or change options at
https://lists.sourceforge.net/lists/listinfo/bitpim-user

There are several hundred people on this list.  Please be
courteous, on topic and follow the instructions before posting
http://www.bitpim.org/help/support.htm