Re: Re:client sdu size.

A little note to add:

You can request a maximum client MRU size of any arbitrary length (0 means
no limit) while sending a Connect request.
But note that because of the nature of capability negotiation, the gateway
can decide to choose a lower client sdu size if they wish.
In that case, there is little that you can do - except for choosing another
gateway.

Experiencewise, I went successfully up to 64 KB that a gateway would send
(not tried anything higher).
But also I found some gateways that would send no more than a 1.5 KB.
Especially the private gateways of network operators.

I am not sure what Kannel does (haven't looked so far into the code).

-- Rene...

--------
This email message has been automatically scanned for viri using Sophos
antivirus.
--------
----- Original Message -----
From: "Rene Kluwen" <[email protected]>
To: "Nigar Sultana" <[email protected]>; <[email protected]>
Sent: Friday, September 20, 2002 3:08 PM
Subject: Re:client sdu size.


> Yes.
>
> Maximum SDU Size is part of capability negociation.
> (Btw, therefore, it can only be set in connection oriented mode).
>
> -- Rene...
>
> ----- Original Message -----
> Date: Fri  September 20, 2002  01:03 PM
> From: Nigar  Sultana <[email protected]>
> To: [email protected]
> Subject: client sdu size.
>
> Hello All
>
> how do we set the the client sdu size, by default it is 1400. we
> want it to be more than 1400. should we set the client sdu size
> during connect req, with in the capabilities,coz i am not sure.
> please help us.
>
> regards
> Nigar
>
>
>