RE: send data message with Siemens M20 ERROR 500

I've seen this problem too, and I think that this is a modem specific problem - I have no problem sending the exact same data on another type of modem. I have yet to find a workaround.

--
Oded Arbel
m-Wise mobile solutions
[email protected]

+972-9-9581711 (116)
+972-67-340014

::..
"The difference between fiction and reality? Fiction has to make sense."
	-- Tom Clancy




> -----Original Message-----
> From: Avner Sternheim [mailto:[email protected]]
> Sent: Tuesday, September 24, 2002 11:36 AM
> To: '[email protected]'
> Subject: send data message with Siemens M20 ERROR 500
> 
> 
> Hi all,
> 
> When I tried to send 8bit messages from the kannel via M20 
> modem and set the
> conding to 8bit (coding=2)
> I got the following error, what is the problem ? and how it 
> can be fixed ?
> 
> 2002-09-24 11:28:48 [6] DEBUG: AT2[/dev/ttyS1]: -->
> 001100098150444640F70004A703FF00FF 
> 2002-09-24 11:28:48 [6] DEBUG: AT2[/dev/ttyS1]: --> ^Z 
> 2002-09-24 11:28:53 [6] DEBUG: AT2[/dev/ttyS1]: <-- > 
> 2002-09-24 11:28:53 [6] DEBUG: AT2[/dev/ttyS1]: <-- +CMS ERROR: 500 
> 2002-09-24 11:28:53 [6] ERROR: AT2[/dev/ttyS1]: CMS ERROR: 
> +CMS ERROR: 500 
> 2002-09-24 11:28:53 [6] DEBUG: AT2[/dev/ttyS1]: send command 
> status: 1 
> 2002-09-24 11:28:53 [1] DEBUG: Dumping 0 messages and 0 acks to store 
> 
> 
>