Re: Splitting makes problem

Shanavaz E A wrote:
> Hi,
> When I send picture messages and logos, kannel is splitting it into 2 
> or 3 parts.
> But this splitting causes sending to fail. When I manually split and send
> them by making a delay(say 100ms) between sending each part, there is
> no problem of failure. Is there any way to avoid this. This manual splitting
> and delaying causes some other problems to me.
> Is there any way to insert some delay between individual parts of messages
> in kannel itself? Or any way to avoid failure without delay itself?
> Can any one help ?

I had a similar problem with a CIMD2 SMSC. I had set the Time To Live to 
-1. This caused the SMSC to fail the second message because the mobile 
phone was busy receiving the first. Setting the TTL to a fixed value 
solved the problem.

-- 
Med vennlig hilsen,
Eurobate ASA

Arne K. Haaje
Senior Network Engineer
--------------------------------------------------------------------
     Eurobate ASA - Postboks 4589 Nydalen - 0404 Oslo - Norway
Phone: +47 23 22 73 73 - Fax: +47 23 22 73 74 - Mob: +47 92 88 44 66
                     http://www.eurobate.com/