Re: smsc_at.c fix

Stipe

Can you do me a favour and commit this.

Regards

Alex

----- Original Message -----
From: "Alex Judd" <[email protected]>
To: "'Kannel Devel'" <[email protected]>
Sent: Tuesday, December 16, 2003 5:04 PM
Subject: smsc_at.c fix


> For those using the AT driver recently you might have noticed it's been
very
> unreliable at opening serial ports properly. This is because part of the
> init code was using the old open_device1 rather than the superior
> open_device function.
>
> If you replace them to use the open_device, serial device opening is
> significantly better - and here's the quick patch
>
> Regards
>
> Alex
>
> --- smsc_at.c   Tue Dec 16 17:33:01 2003
> +++ smsc_at.c.alex      Tue Dec 16 17:31:44 2003
> @@ -2104,7 +2104,7 @@
>
>      int res;
>
> -    if (at2_open_device1(privdata) == -1)
> +    if (at2_open_device(privdata) == -1)
>         return -1;
>
>      at2_set_speed(privdata, speed);
> @@ -2130,7 +2130,7 @@
>
>      debug("bb.smsc.at2", 0, "AT2[%s]: detecting modem type",
> octstr_get_cstr(privdata->name));
>
> -    if (at2_open_device1(privdata) == -1)
> +    if (at2_open_device(privdata) == -1)
>          return -1;
>
>      at2_set_speed(privdata, privdata->speed);
>