Re: AT Modem

do you have documentation about the AT commandset of that modem?
The ones used by kannel are standardized in some GSM spec even though  
some older modems sometimes have variants which have less parameters  
etc. Some modems simply don't support certain operations which means  
you would end up in a dead end.

Its important to put log-level to 0 to see all the commands being sent  
and returned to debug this. Can be something simple like wrong serial  
port speed or wrong port too.


On 03.11.2007, at 13:39, Khan, Hammad Aslam wrote:

> Hello everyone,
>
> Using a GSM Modem (Huawei E630) i can successfully send SMS but  
> receiving is not working at all.
> I know CNMI configuration may have direct impact on message receive  
> notification; but I have set it with different/all possible  
> combinations even then its not working.
>
> I suppose; as AT+CNMI is configured by its default program i.e.  
> (1,1,0,1,0) should work.
>
> Does someone have any idea about possible configurations of modem in  
> modem.conf or any other idea about how can it work?
>
> Regards,
> Hammad
> FlexilogiX Inc.