Re: Urgent Need Help in SMPP

I have tried this but in some cases bearer-box  send (in some case to maintain 
it load balance) these messages to  other smsc_id's i don't know why?



________________________________
From: Rene Kluwen <[email protected]>
To: adil nazir <[email protected]>; Nikos Balkanas <[email protected]>
Cc: [email protected]
Sent: Thu, August 12, 2010 12:11:00 PM
Subject: RE: Urgent Need Help in SMPP

 
1.       Specify *all* other smsc’s in denied-smsc-id, separated by semicolons 
(;).
2.       Always specify &smsc=…. In your sendsms url.
 
== Rene
 
 
From:[email protected] [mailto:[email protected]] On Behalf Of 
adil nazir
Sent: Thursday, 12 August, 2010 07:06
To: Nikos Balkanas
Cc: [email protected]
Subject: Re: Urgent Need Help in SMPP
 

SMSC may not contain the accepted_smsc variable. I want to use denied-smsc-id 
with smsc of type smpp but when i do so still my smsc can accept messages of all 
other smsc's. Tell me what can i do?
 
 

________________________________
 
From:Nikos Balkanas <[email protected]>
To: adil nazir <[email protected]>
Sent: Thu, August 12, 2010 2:22:35 AM
Subject: Re: Urgent Need Help in SMPP

Address list so that others may benefit/offer insight. Do not send me 
personnals.
----- Original Message ----- From: adil nazir
To: Nikos Balkanas
Sent: Wednesday, August 11, 2010 2:29 PM
Subject: Re: Urgent Need Help in SMPP


SMSC may not contain the accepted_smsc variable. I want to use denied-smsc-id 
with smsc of type smpp but when i do so still my smsc can accept messages of all 
other smsc's. Tell me what can i do?





From: Nikos Balkanas <[email protected]>
To: adil nazir <[email protected]>; [email protected]
Sent: Wed, August 11, 2010 3:11:07 PM
Subject: Re: Urgent Need Help in SMPP

Hi,

Don't do work already done. The SMPP drivers are in gw/smsc/*smpp.c.

1) Priority queue works. Recheck.

2) This is fully functional. You need a combination of accepted-smsc and 
denied-smsc. Read examples in User's guide.

BR,
Nikos
----- Original Message ----- From: adil nazir
To: [email protected]
Sent: Wednesday, August 11, 2010 9:53 AM
Subject: Urgent Need Help in SMPP


Please can any one tell me that how can i extract SMPP code from kannel. I want 
to develop my own application using SMPP i want this because of following 
reasons:
1. In existing kannel i am unable to give high priority to the massages already 
in queue i have also used (0-3) priority but still its behavior is same.
2. Also existing kannel route the massage to any SMSC in multiple SMSC 
environment. I have tried to use "denied-smsc-id" but still when one SMSC goes 
down (means not responding but not alive )  kannel route message to the other 
SMSC.

So that is why i want to extract SMPP module from kannel so guide me how can i 
do this i am new on kannel source code. Also if you have any other solution then 
tell me but reply as soon as possible.

Regards,

Adil