Re: Urgent Need Help in SMPP

Read user's guide. It has lots of examples. Afterwards if you have specific 
questions ask the list.

BR,
Nikos
----- Original Message ----- 
From: adil nazir
To: Nikos Balkanas
Cc: [email protected]
Sent: Thursday, August 12, 2010 8:06 AM
Subject: Re: Urgent Need Help in SMPP



SMSC may not contain the accepted_smsc variable. I want to use 
denied-smsc-id with smsc of type smpp but when i do so still my smsc can 
accept messages of all other smsc's. Tell me what can i do?






From: Nikos Balkanas <[email protected]>
To: adil nazir <[email protected]>
Sent: Thu, August 12, 2010 2:22:35 AM
Subject: Re: Urgent Need Help in SMPP

Address list so that others may benefit/offer insight. Do not send me 
personnals.
----- Original Message ----- From: adil nazir
To: Nikos Balkanas
Sent: Wednesday, August 11, 2010 2:29 PM
Subject: Re: Urgent Need Help in SMPP


SMSC may not contain the accepted_smsc variable. I want to use 
denied-smsc-id with smsc of type smpp but when i do so still my smsc can 
accept messages of all other smsc's. Tell me what can i do?





From: Nikos Balkanas <[email protected]>
To: adil nazir <[email protected]>; [email protected]
Sent: Wed, August 11, 2010 3:11:07 PM
Subject: Re: Urgent Need Help in SMPP

Hi,

Don't do work already done. The SMPP drivers are in gw/smsc/*smpp.c.

1) Priority queue works. Recheck.

2) This is fully functional. You need a combination of accepted-smsc and 
denied-smsc. Read examples in User's guide.

BR,
Nikos
----- Original Message ----- From: adil nazir
To: [email protected]
Sent: Wednesday, August 11, 2010 9:53 AM
Subject: Urgent Need Help in SMPP


Please can any one tell me that how can i extract SMPP code from kannel. I 
want to develop my own application using SMPP i want this because of 
following reasons:
1. In existing kannel i am unable to give high priority to the massages 
already in queue i have also used (0-3) priority but still its behavior is 
same.
2. Also existing kannel route the massage to any SMSC in multiple SMSC 
environment. I have tried to use "denied-smsc-id" but still when one SMSC 
goes down (means not responding but not alive )  kannel route message to the 
other SMSC.

So that is why i want to extract SMPP module from kannel so guide me how can 
i do this i am new on kannel source code. Also if you have any other 
solution then tell me but reply as soon as possible.

Regards,

Adil