Re: [PATCH] allow setting service-type for SMPP SMSC

try to match the below

# SMSC
group = smsc
smsc = smpp
smsc-id = myid
allowed-smsc-id = myid
preferred-smsc-id = myid
interface-version = 34
host = xx.xx.xx.xx.
port = xxxx
receive-port = 0
transceiver-mode = 0
smsc-username = user
smsc-password = pass
system-type = VMA
source-addr-ton = 5
source-addr-npi = 1
dest-addr-ton = 0
dest-addr-npi = 0
keepalive = 600
reconnect-delay = 3
enquire-link-interval = 30
esm-class = 0
#max-pending-submits = 50
#throughput = 50
#wait-ack = 240
#wait-ack-expire = 0x00
msg-id-type = 0x01
log-level = 0
log-file = /var/log/kannel/myid.log

On Mon, Nov 12, 2018 at 9:47 PM christopher kamutumwa <
[email protected]> wrote:

> Below are variables and operator says the are ok; just the variable for
> service-type which is not parsing the correct variable
>
> group = smsc
> smsc = smpp
> smsc-id = zoned
> host = 172.xx.xx.xxx
> port = 5001
> interface-version = 34
> smsc-username = xxxxxx
> smsc-password = xxxxxx
> system-type = "smpp"
> service-type = smpp
> #allowed-prefix = 26097
> source-addr-ton = 5
> source-addr-npi = 0
> dest-addr-ton = 1
> dest-addr-npi = 1
> transceiver-mode = true
> throughput = 40
>
> Thanks in advance
>
> Chris
>
> On Mon, Nov 12, 2018 at 8:17 PM Web Min <[email protected]> wrote:
>
>> what is your smsc variables? in kannel.conf
>>
>> On Mon, Nov 12, 2018 at 9:13 PM christopher kamutumwa <
>> [email protected]> wrote:
>>
>>> hello,
>>> where can I find this patch I have noticed when service-type= smpp is
>>> put in config log shows NOBAL instead of smpp. hence getting error INVALID
>>> SERVICE_TYPE. does anyone have a patch to make it work. or a fix to this
>>> problem
>>>
>>> Thanks
>>>
>>> Chris
>>>
>>