Re: [PATCH] allow setting service-type for SMPP SMSC

this hasn't worked I did but same error

On Mon, Nov 12, 2018 at 9:02 PM Web Min <[email protected]> wrote:

> try to match the below
>
> # SMSC
> group = smsc
> smsc = smpp
> smsc-id = myid
> allowed-smsc-id = myid
> preferred-smsc-id = myid
> interface-version = 34
> host = xx.xx.xx.xx.
> port = xxxx
> receive-port = 0
> transceiver-mode = 0
> smsc-username = user
> smsc-password = pass
> system-type = VMA
> source-addr-ton = 5
> source-addr-npi = 1
> dest-addr-ton = 0
> dest-addr-npi = 0
> keepalive = 600
> reconnect-delay = 3
> enquire-link-interval = 30
> esm-class = 0
> #max-pending-submits = 50
> #throughput = 50
> #wait-ack = 240
> #wait-ack-expire = 0x00
> msg-id-type = 0x01
> log-level = 0
> log-file = /var/log/kannel/myid.log
>
> On Mon, Nov 12, 2018 at 9:47 PM christopher kamutumwa <
> [email protected]> wrote:
>
>> Below are variables and operator says the are ok; just the variable for
>> service-type which is not parsing the correct variable
>>
>> group = smsc
>> smsc = smpp
>> smsc-id = zoned
>> host = 172.xx.xx.xxx
>> port = 5001
>> interface-version = 34
>> smsc-username = xxxxxx
>> smsc-password = xxxxxx
>> system-type = "smpp"
>> service-type = smpp
>> #allowed-prefix = 26097
>> source-addr-ton = 5
>> source-addr-npi = 0
>> dest-addr-ton = 1
>> dest-addr-npi = 1
>> transceiver-mode = true
>> throughput = 40
>>
>> Thanks in advance
>>
>> Chris
>>
>> On Mon, Nov 12, 2018 at 8:17 PM Web Min <[email protected]> wrote:
>>
>>> what is your smsc variables? in kannel.conf
>>>
>>> On Mon, Nov 12, 2018 at 9:13 PM christopher kamutumwa <
>>> [email protected]> wrote:
>>>
>>>> hello,
>>>> where can I find this patch I have noticed when service-type= smpp is
>>>> put in config log shows NOBAL instead of smpp. hence getting error INVALID
>>>> SERVICE_TYPE. does anyone have a patch to make it work. or a fix to this
>>>> problem
>>>>
>>>> Thanks
>>>>
>>>> Chris
>>>>
>>>