Re: sms_modem config question

Michael,
It looks like your modem is resetting (ATZ), expecting ok? (<OK)- not 
sure if that is ok and then disabling error correction (AT&E).

Check your initialization string in sms_modem file... I would expect 
that it should just say: MDM_init_command       = "Z"
However you may need more in there... but try that.

What do you get after the "Received String: ....." line, or does it stop 
there?

Andrew Lowe



Michael Huettig wrote:

>Hi everybody,
>i´m trying to install sms_client 2.0.8y with AVM B1 (ttyI0) for use with german telecom. After Dialing i receive the following error:
>
>test:~ # sms_client -l4 017xyyyyyyy blabla
>...
>Created Lockfile '/var/spool/locks//LCK..ttyI0'
>MODEM: Toggle DTR 2000000 Microseconds
>MODEM: Toggle DTR 2000000 Microseconds
>MDM_send: Drain required.
>WARNING: read() Timeout
>MODEM: Sending Initialization string ATZ<CR> <OK AT&E0<CR> to modem
>Written String: +ATZ<CR> <OK AT&E0<CR>+
>Received String: +ATZ<CR><CR><LF>OK<CR><LF> <OK +
>
>Could anybody give me a hint, whats wrong with my config?
>I´m trying to modify different item´s in /etc/sms/sms_modem but nothing helps ...
>
>Regards
>Michael
>
>
>**********************************************************************
>Diese E-Mail wurde auf Viren ueberprueft.
>www.mimesweeper.com
>**********************************************************************
>
>
>--
>
>-----------------------------------------------------------------------
>This is the SMSClient Users Mailman Mailing List
>Please Post to: [email protected]
>List Interface: http://mailman.smsclient.org./mailman/listinfo/users
>List Archive: http://mailman.smsclient.org/mailman/private/users/
>-----------------------------------------------------------------------
>  
>


--

-----------------------------------------------------------------------