Re: Canon 77D

Hi,

If you are using 2.5.13 can you switch to 2.5.14?

Ciao, Marcus
On Fri, Aug 18, 2017 at 11:37:24AM +0200, Marcus Meissner wrote:
> On Thu, Aug 17, 2017 at 11:21:30PM -0700, Sean McCauliff wrote:
> > I seem to be able to detect this camera without any problem and set
> > the parameters I care to set.  However, I don't seem to be able to
> > take a photo.  I don't care about downloading any of the images I just
> > want them to say on the card on the camera.  When I trigger with :
> > 
> > gphoto2 --set-config eosremoterelease="Press Full"
> > or
> > gphoto2 --set-config eosremoterelease=Immediate
> > 
> > the camera crashes with Error 70 on the camera screen.
> > gphoto2 --capture-image
> > 
> > Does not seems to do anything.
> > 
> > Any tips?
> 
> Is capturetarget set to CARD?
> 
> Can you use --trigger-capture or does that also cause Error 70?
> 
> Ciao, Marcus
> 
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> Gphoto-user mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/gphoto-user

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot