Nikon D5100 burst error

Hello everybody,

I need to do quick doubleshot through libgphoto and I perfectly can do 
this with SD card.

But if I try to avoid using it I have an error for first shot. Each next 
one in burst seria is ok, but each first one is failure.

Can you suggest me how to operate in this case avoiding the failure?


gphoto2 --auto-detect --shell
Model Port
----------------------------------------------------------
Nikon DSC D5100 (PTP mode)     usb:002,013
gphoto2: {/home/slava} /> set-config capturemode=1
gphoto2: {/home/slava} /> set-config burstnumber=2
gphoto2: {/home/slava} /> set-config capturetarget=0
gphoto2: {/home/slava} /> capture-image
ERROR: Could not capture image.
ERROR: Could not capture.
New file is in location /capt0000.jpg on the camera
gphoto2: {/home/slava} /> capture-image
ERROR: Could not capture image.
ERROR: Could not capture.
New file is in location /capt0001.jpg on the camera
gphoto2: {/home/slava} /> set-config capturetarget=1
gphoto2: {/home/slava} /> capture-image
New file is in location /store_00010001/DCIM/103D5100/DSC_0012.JPG on 
the camera
New file is in location /store_00010001/DCIM/103D5100/DSC_0013.JPG on 
the camera
gphoto2: {/home/slava} />

gphoto2 --version
gphoto2 2.5.17

-- 
Slava Garelin
skype: garelin

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
Gphoto-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/gphoto-user