On Fri, Aug 21, 2009 at 7:58 AM, Jesús Díaz
Vico<[email protected]> wrote:
> Hello,
>
> I have two questions concerning floor1 encoding/decoding. First I'll ask
> about the FLOOR1_fromdB_LOOKUP table: what is it's purpose? Is it to convert
> the amplitude differences between [floor1_Y] values to a dB scale?
from a dB scale, not to.
> And, if
> I'm right with that, here comes the 2nd question: when render_line0 is used
> to encode floor1, then floor1_inverse2 must be used in decode (in order to
> convert to dB scale), and, in the other hand, if render_line is used to
> encode, then floor1_inverse1 must be used in decode (render_line converts to
> dB and therefore floor1_inverse1 gets the amplitudes in dB). If all my
> suppositions are right, is there any recommendation or something like that
> to decide whether to use one combination or the other?
...huh? Completely lost too :-)
encoding and interpolation are done in dB, and then the resulting
curve is converted to linear.
Monty
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.