Re: rhea & cores

Chris,When you only use the logic what transfers data to the FPGA?
Have a Happy New Year.Regards, Edward Vidal Jr. e-mail [email protected] 915-595-1613 

    On Tuesday, December 29, 2015 4:25 PM, Christopher Felton <[email protected]> wrote:
 

 On 12/29/15 5:05 PM, Edward Vidal wrote:
> Chris , The example you  provided should also work with a XulA2-LX9
> is that correct?

Yes it should, you need the correct PMODs
for the Xula2 and stickit.

> I have downloaded IceCube2 but have not installed
> it?  Which version of IceCube2 have you tested Linux or window?

IceCub2 2015.08.27744 on linux, Ubuntu 15.10.

> I
> normally work on a Ubuntu 12.04 this is where I have the Xilinx
> 14.6. Which board has the highest priority?

Not sure what you mean, highest priority?  From
my point of view a design should work with many
different boards - no board really has a priority.

> I also have been looking
> at the Parallella & zybo. Are these 2 boards easier to work with than
> the Zedboard.

Don't know, haven't used a Zedboard, the Zybo is
easier to use than the Parallella.

> I have an Yocto O/S working but nothing in the FPGA
> side. Are you working on theses board using the Zynq 7000?

Yes, the Zynq 7010 and 7020 I only use the logic
side I don't do anything with the PS.

Regards,
Chris


------------------------------------------------------------------------------
_______________________________________________
myhdl-list mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/myhdl-list

------------------------------------------------------------------------------

_______________________________________________
myhdl-list mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/myhdl-list