Re: rhea & cores

On 12/29/15 5:35 PM, Edward Vidal wrote:
> Chris,
> When you only use the logic what transfers data to the FPGA?

Depends on what interface I want to use. One
can use the logic to drive the interface: UART,
Ethernet, etc.

Regards,
Chris

>
> Have a Happy New Year.
> Regards,
> Edward Vidal Jr. e-mail [email protected] 915-595-1613
>
>
> On Tuesday, December 29, 2015 4:25 PM, Christopher Felton 
> <[email protected]> wrote:
>
>
> On 12/29/15 5:05 PM, Edward Vidal wrote:
> > Chris , The example you  provided should also work with a XulA2-LX9
> > is that correct?
>
> Yes it should, you need the correct PMODs
> for the Xula2 and stickit.
>
> > I have downloaded IceCube2 but have not installed
> > it?  Which version of IceCube2 have you tested Linux or window?
>
> IceCub2 2015.08.27744 on linux, Ubuntu 15.10.
>
> > I
> > normally work on a Ubuntu 12.04 this is where I have the Xilinx
> > 14.6. Which board has the highest priority?
>
> Not sure what you mean, highest priority?  From
> my point of view a design should work with many
> different boards - no board really has a priority.
>
> > I also have been looking
> > at the Parallella & zybo. Are these 2 boards easier to work with than
> > the Zedboard.
>
> Don't know, haven't used a Zedboard, the Zybo is
> easier to use than the Parallella.
>
> > I have an Yocto O/S working but nothing in the FPGA
> > side. Are you working on theses board using the Zynq 7000?
>
> Yes, the Zynq 7010 and 7020 I only use the logic
> side I don't do anything with the PS.
>
>
> Regards,
> Chris
>
>
> ------------------------------------------------------------------------------
> _______________________________________________
> myhdl-list mailing list
> [email protected] <mailto:[email protected]>
> https://lists.sourceforge.net/lists/listinfo/myhdl-list
>
>

------------------------------------------------------------------------------

_______________________________________________
myhdl-list mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/myhdl-list