Re: EEG-SMT USB Interface

No, you can't make the EEG show up as anything but a serial port. The COM
port behavior is a hardware thing. Specifically, it's an FTDI chip. You'd
have to ask the user which COM port it is, similar to how the arduino
environment does on the older boards. In fact, it's the same chip, so you
could probably use a lot of the arduino's code.


On Tue, Nov 27, 2012 at 11:08 PM, David Warwick <[email protected]> wrote:

> Is it possible to set the USB interface on the EEG-SMT to be a generic
> device that is not a COM port?
>
> I've written a Java based EEG reader in Linux for Stefan Jung's EXG2, and
> I'd like to also use the EEG-SMT.  The EEG-SMT does not show up in a USB
> device scan, so I'm not able to discern the vendor and product ID.
>
> I don't have a lot of experience in writing device drivers, so apologies
> in advance if this has already been covered.
>
>
>
> ------------------------------------------------------------------------------
> Keep yourself connected to Go Parallel:
> INSIGHTS What's next for parallel hardware, programming and related areas?
> Interviews and blogs by thought leaders keep you ahead of the curve.
> http://goparallel.sourceforge.net
> _______________________________________________
> Openeeg-list mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/openeeg-list
> Go to the above address to change your
> subscription options, e.g unsubscribe.
>
>

------------------------------------------------------------------------------
Keep yourself connected to Go Parallel: 
VERIFY Test and improve your parallel project with help from experts 
and peers. http://goparallel.sourceforge.net