TXD, RXD, and ground connections
Nelson Liu <[email protected]>
| Newsgroups | gmane.comp.science.openeeg.general |
|---|---|
| Message-ID | <CALoLHMLZ4VBbu4ZN0SHeZMEkcH9cE-8+mGinYak6uCZp8stDKA@mail.gmail.com> |
Hi Everyone, Sorry for asking what may seem like an obvious question, but I can't seem to figure this simple thing out. How should I connect the TXD, RXD, and ground to the pc? Do i put a 3-pin socket in the TXD, RXD, and ground indicators on the digital board and use a serial 9-pin male connector, or do i put a 3-pin pinhead into TXD, RXD and GND, and use a 3-pin female connector? Also, looking at pinouts, it seems like as if TXD is 2, RXD is 3, and GND is 5. Is this correct (do i only connect those 3 pins, and leave everything else hanging)? Sorry, and thanks in advance for the help! Nelson Liu ------------------------------------------------------------------------------ Introducing Performance Central, a new site from SourceForge and AppDynamics. Performance Central is your source for news, insights, analysis and resources for efficient Application Performance Management. Visit us today! http://pubads.g.doubleclick.net/gampad/clk?id=48897511&iu=/4140/ostg.clktrk