Re: VMWare m0n0 NIC setup?

Assuming that your normal network is NOT 192.168.1.x you can configure 
VMWare to use that network.  The 2 you gave are selected at install time 
(VMWare, not m0n0) and I've never seen to machines pick the same set of 
networks.  You can however control that selection as part of the VMWare 
configuration.  It's been quite some time since I've done it so I'll 
refer you to the VMWare site for details.


On 5/5/2010 11:01 AM, Andrew @ ATM Logic wrote:
> I have always ran the basic PC hardware m0n0 boxes, but I am getting tired
> of them dying every 3 years...  ;-)  So I want to move to virtual.
>
>
>
> However I just don't quite understand it...  I have a PC with the two NIC's
> in it, The VMware image fires up fine, but... now what?
>
>
>
> ipconfig shows 192.168.249.1 and 192.168.49.1 or something similar, I would
> like my m0n0 on the default 192.168.1.1  what do I have to do to make it
> work?
>
>
>
> The hardware is Intel and Realtek, m0n0 VM ware shows them as em0 and em1
> ... I am guessing this is normal...  I have clicked on bind to other
> adaptors etc..
>
>
>
> anyone have a simple how to for this?
>
>
>
> Thanks.
>
>
>