RE: Install Monowall on USB Thumb Drive?

 
Is the CF image the same as the Generic PC image? I Use only 32MB Old USB
Drive.

Can you tell me what GUI tool you are using to copy the image to the USB? I
used the physdiskwrite.exe tool and it always returns error.

Thanks
Rendra

-----Original Message-----
From: Heinz Teichmann [mailto:[email protected]] 
Sent: Friday, September 24, 2010 2:32 PM
To: Gold Dragon
Subject: FW: [m0n0wall] Install Monowall on USB Thumb Drive?




I did it with the normal CF image. I think there is a limitation regarding
the size. First time I tried it with a 100 GB USB HDD, it didn't load the
image up and came up with a fault. Second time I used a 1 GB USB Stick and
that worked well. I used that GUI tool to install the image and that doesn't
return any errors, so use the CLI if you want to make sure that it had been
copied correctly.
I dumped Monowall again because of the VPN issues with Dynamic DNS. I need a
stable VPN with two AVM Fritz boxes behind dyndns and that is not achievable
with Monowall. Unfortunately. Because I think it's great otherwise.

HT

-----Original Message-----
From: David Burgess [mailto:[email protected]]
Sent: Friday, 24 September 2010 1:56 PM
Cc: [email protected]
Subject: Re: [m0n0wall] Install Monowall on USB Thumb Drive?

On Thu, Sep 23, 2010 at 11:50 PM, GD Incorporation
<[email protected]> wrote:
> Can anyone tell me how to install m0n0wall 1.32 on USB thumb drive?

Have you tried just following the instructions for CF installation?
That's where I would start, then make sure your BIOS is set to boot from the
USB device. I did a FreeNAS install on USB once, and I think that's how I
did it.

db

---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]



www.thewest.com.au

----------------------------------------------------------------------------
--------
West Australian Newspapers Group
----------------------------------------------------------------------------
--------
Privacy and Confidentiality Notice

The information contained herein and any attachments are intended solely for
the named recipients. It may contain privileged confidential information.
If you are not an intended recipient, please delete the message and any
attachments then notify the sender. Any use or disclosure of the contents of
either is unauthorised and may be unlawful. Any liability for viruses is
excluded to the fullest extent permitted by law.

Advertising Terms & Conditions
Please refer to the current rate card for advertising terms and conditions.
The rate card is available on request or via www.thewest.com.au/ratecard

Unsubscribe
If you do not wish to receive emails such as this in future please reply to
it with "unsubscribe" in the subject line.