Re: Install Monowall on USB Thumb Drive?

  Make sure to run physdiskwrite as "administrator" (even if you are 
admin !), winvista or win7 !

Op 24/09/2010 10:37, GD Incorporation schreef:
>
> Is the CF image the same as the Generic PC image? I Use only 32MB Old USB
> Drive.
>
> Can you tell me what GUI tool you are using to copy the image to the USB? I
> used the physdiskwrite.exe tool and it always returns error.
>
> Thanks
> Rendra
>
> -----Original Message-----
> From: Heinz Teichmann [mailto:[email protected]]
> Sent: Friday, September 24, 2010 2:32 PM
> To: Gold Dragon
> Subject: FW: [m0n0wall] Install Monowall on USB Thumb Drive?
>
>
>
>
> I did it with the normal CF image. I think there is a limitation regarding
> the size. First time I tried it with a 100 GB USB HDD, it didn't load the
> image up and came up with a fault. Second time I used a 1 GB USB Stick and
> that worked well. I used that GUI tool to install the image and that doesn't
> return any errors, so use the CLI if you want to make sure that it had been
> copied correctly.
> I dumped Monowall again because of the VPN issues with Dynamic DNS. I need a
> stable VPN with two AVM Fritz boxes behind dyndns and that is not achievable
> with Monowall. Unfortunately. Because I think it's great otherwise.
>
> HT
>
> -----Original Message-----
> From: David Burgess [mailto:[email protected]]
> Sent: Friday, 24 September 2010 1:56 PM
> Cc: [email protected]
> Subject: Re: [m0n0wall] Install Monowall on USB Thumb Drive?
>
> On Thu, Sep 23, 2010 at 11:50 PM, GD Incorporation
> <[email protected]>  wrote:
>> Can anyone tell me how to install m0n0wall 1.32 on USB thumb drive?
> Have you tried just following the instructions for CF installation?
> That's where I would start, then make sure your BIOS is set to boot from the
> USB device. I did a FreeNAS install on USB once, and I think that's how I
> did it.
>
> db
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>
>
>
> www.thewest.com.au
>
> ----------------------------------------------------------------------------
> --------
> West Australian Newspapers Group
> ----------------------------------------------------------------------------
> --------
> Privacy and Confidentiality Notice
>
> The information contained herein and any attachments are intended solely for
> the named recipients. It may contain privileged confidential information.
> If you are not an intended recipient, please delete the message and any
> attachments then notify the sender. Any use or disclosure of the contents of
> either is unauthorised and may be unlawful. Any liability for viruses is
> excluded to the fullest extent permitted by law.
>
> Advertising Terms&  Conditions
> Please refer to the current rate card for advertising terms and conditions.
> The rate card is available on request or via www.thewest.com.au/ratecard
>
> Unsubscribe
> If you do not wish to receive emails such as this in future please reply to
> it with "unsubscribe" in the subject line.
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>