Re: VPN client issue

Hi Sam,

> How is the =B3My Identifier=B2 field supposed to be filled in when you ha=
ve
> multiple remote IPSEC VPN clients?

I don't recall IPsec on the m0n0wall, but on pfSense I always the set=20
the Phase 1 entry "Ny identifier" to "My IP address". Negotiation mode=20
is aggressive.

Best regards, Klaus

Thursday, June 12, 2014, 5:12:20 PM, you wrote:

> Gang,

> I am having an issue where VPN clients stop working for traffic. They can
> connect, and the client shows a connection, but no data passes. They can
> reboot and reconnect all day long, but the VPN will always connect, but
> never work.

> The temporary fix is to go to the m0n0wall GUI, VPN =8B> IPSEC =8B> Mobile
> Clients tab, and put the user having trouble in the =B3My Identifier=B2 f=
ield
> and saving the config again.

> How do I make the user account work permanently?

> How is the =B3My Identifier=B2 field supposed to be filled in when you ha=
ve
> multiple remote IPSEC VPN clients?

> I am running v.1.8.1, and this issue started when I switched to 1.8.1. (I
> was on some older version, not sure which one anymore)

> Thanks!

> Sam


> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]





--=20
Best regards,
 Klaus                            mailto:[email protected]