Re: asa 5505 vpn ipsec l2l problem

I don't know if you got my older email, here it is again:

Run these three debugs
debug crypto engine
debug crypto isakmp 127
debug crypto ipsec 127
and then see if you get any more meaningful debugs.

Its better to clear both Phase 1 and Phase 2 before you run the debugs (just
in case the SAs are already established).

Also try removing the crypto map from the interface and re-applying it!

Please also check the logging levels on your ASA 'show logging'

logging buffered 7
logging monitor 7  (save/log the telnet session after issuing the 'terminal
monitor' command)


Regards

Farrukh



On Sat, Oct 3, 2009 at 3:38 PM, Hrvoje Popovski <[email protected]> wrote:

>  > If you're not seeing IPsec build the tunnel with debug crypto, I would
>
>> guess that traffic is getting NAT'd out, and not hitting the tunnel (by
>> the way, you probably only need debug crypto ipsec 5, not 100...)
>>
>>
>> Do you have NAT setup on the 5505? If you do, do you have a NAT exclude
>> ACL setup that excludes "your device networks -> remote device networks"?
>>
>> --
>> Eric
>>
>>
> hello eveyone,
>
> first thanks everyone who replay on my post.
> I can't established SA, crypto acl is the same on both ends, well they tell
> me so. I can't see config on other side but maybe from log that i can se on
> my ASA i think that problem is on my side. I realy don't know maybe problem
> is in licence (10 inside hosts) but i have only 2 inside hosts
> (192.168.11.11 and 11.12).
> I will try to apply crypto acl with ip rule and see what happens.
>
> ---------------------------------
> log:
> Ignoring msg to mark SA with specified coordinates <abcMap, 1> dead
>
> debug crypto engine, ipsec 127 and ipsec 127 gave me nothing
>
> ---------------------------------
> my asa:
> ciscoasa# sh crypto isakmp sa
> There are no isakmp sas
>
> ciscoasa# sh crypto ipsec sa
> There are no ipsec sas
> ---------------------------------
> my asa - 22.22.22.22
> other asa - 33.33.33.33
> -----------------------------------------------
> config on 33.33.33.33 asa:
> access-list acl1 permit tcp host 10.1.100.13 eq 4000 host 192.168.11.11
> access-list acl1 permit tcp host 10.1.110.250 eq 4000 host 192.168.11.11
> access-list acl1 permit tcp host 10.1.100.105 eq ftp host 192.168.11.11 eq
> ftp
> access-list acl1 permit tcp host 10.1.100.105 eq ftp-data host
> 192.168.11.11
> access-list acl1 permit tcp host 10.1.100.13 eq 4000 host 192.168.11.12
> access-list acl1 permit tcp host 10.1.110.250 eq 4000 host 192.168.11.12
> access-list acl1 permit tcp host 10.1.100.105 eq ftp host 192.168.11.12
> access-list acl1 permit tcp host 10.1.100.105 eq ftp-data host
> 192.168.11.12
>
> transform-set esp-3des esp-md5-hmac
>
> isakmp key * address 22.22.22.22 netmask 255.255.255.255 no-xauth
> no-config-mode
>
> this is all information that i know
>
> -------------------------------------------------
>
> here is my config - 22.22.22.22 asa:
>
> ASA Version 7.2(4)
> !
> hostname ciscoasa
> domain-name default.domain.invalid
> names
> !
> interface Vlan1
>  nameif inside
>  security-level 100
>  ip address 192.168.11.254 255.255.255.0
> !
> interface Vlan2
>  nameif outside
>  security-level 10
>  ip address 22.22.22.22 255.255.255.0
> !
> interface Ethernet0/0
>  switchport access vlan 2
> !
> interface Ethernet0/1
> !
> interface Ethernet0/2
> !
> interface Ethernet0/3
> !
> interface Ethernet0/4
> !
> interface Ethernet0/5
> !
> interface Ethernet0/6
> !
> interface Ethernet0/7
> !
> boot system disk0:/asa724-k8.bin
> ftp mode passive
> clock timezone CEST 1
> clock summer-time CEDT recurring last Sun Mar 2:00 last Sun Oct 3:00
> dns server-group DefaultDNS
>  domain-name default.domain.invalid
> access-list NoNAT extended permit ip host 192.168.11.11 host 10.1.100.13
> access-list NoNAT extended permit ip host 192.168.11.11 host 10.1.100.105
> access-list NoNAT extended permit ip host 192.168.11.11 host 10.1.110.250
> access-list NoNAT extended permit ip host 192.168.11.12 host 10.1.100.13
> access-list NoNAT extended permit ip host 192.168.11.12 host 10.1.100.105
> access-list NoNAT extended permit ip host 192.168.11.12 host 10.1.110.250
> access-list ACL1 extended permit tcp host 192.168.11.11 host 10.1.100.13 eq
> 4000
> access-list ACL1 extended permit tcp host 192.168.11.11 host 10.1.110.250
> eq 4000
> access-list ACL1 extended permit tcp host 192.168.11.11 eq ftp host
> 10.1.100.105 eq ftp
> access-list ACL1 extended permit tcp host 192.168.11.11 host 10.1.100.105
> eq ftp-data
> access-list ACL1 extended permit tcp host 192.168.11.12 host 10.1.100.13 eq
> 4000
> access-list ACL1 extended permit tcp host 192.168.11.12 host 10.1.110.250
> eq 4000
> access-list ACL1 extended permit tcp host 192.168.11.12 host 10.1.100.105
> eq ftp
> access-list ACL1 extended permit tcp host 192.168.11.12 host 10.1.100.105
> eq ftp-data
> pager lines 24
> logging enable
> logging timestamp
> logging buffer-size 10000
> logging buffered debugging
> logging asdm informational
> mtu inside 1500
> mtu outside 1500
> icmp unreachable rate-limit 1 burst-size 1
> icmp permit any inside
> icmp permit any outside
> asdm image disk0:/asdm-522.bin
> no asdm history enable
> arp timeout 14400
> nat-control
> nat (inside) 0 access-list NoNAT
> static (inside,outside) 192.168.113.11 192.168.11.11 netmask
> 255.255.255.255
> static (inside,outside) 192.168.113.12 192.168.11.12 netmask
> 255.255.255.255
> *i need this static nat but not for now*
> route inside 192.168.10.0 255.255.255.0 192.168.11.1 1
> route outside 0.0.0.0 0.0.0.0 22.22.22.1 1
>
> crypto ipsec transform-set ESP-AES256-SHA esp-aes-256 esp-sha-hmac
> crypto ipsec transform-set ESP-3DES-MD5 esp-3des esp-md5-hmac
> crypto map abcMap 1 match address ACL1
> crypto map abcMap 1 set peer 33.33.33.33
> crypto map abcMap 1 set transform-set ESP-3DES-MD5
> crypto map abcMap 1 set security-association lifetime seconds 3600
> crypto map abcMap 1 set security-association lifetime kilobytes 2560
> crypto map abcMap interface outside
> crypto isakmp identity address
> crypto isakmp enable outside
> crypto isakmp policy 1
>  authentication pre-share
>  encryption 3des
>  hash md5
>  group 2
>  lifetime 86400
> crypto isakmp policy 2
>  authentication pre-share
>  encryption aes
>  hash sha
>  group 2
>  lifetime 86400
> crypto isakmp nat-traversal  20
>
> ntp server 192.168.10.2
> ntp server 192.168.10.3
> ssl encryption des-sha1
>
> tunnel-group DefaultL2LGroup ipsec-attributes
>  isakmp keepalive threshold 120 retry 10
> tunnel-group DefaultRAGroup ipsec-attributes
>  isakmp keepalive threshold 120 retry 10
> tunnel-group 33.33.33.33 type ipsec-l2l
> tunnel-group 33.33.33.33 ipsec-attributes
>  pre-shared-key *
>
> !
> !
> prompt hostname context
> Cryptochecksum:ad3bf9e8fef81844b866e79c1b0c8e2f
> : end
>
> --
>
> /hrvoje
>
> _______________________________________________
> firewall-wizards mailing list
> [email protected]
> https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards
>

_______________________________________________
firewall-wizards mailing list
[email protected]
https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards