HoneyD-Win32 Parse Error --- ROADBLOCK

Hi Roger -

First of all thank you for writing your book.  After weeks of research I
finally ran across it and it put all of the pieces together for me.
Well, almost all of the pieces.

I have installed HoneyD-Win32 as described in your book and if I simply
run the command "honeyd -d" it pops up and says it is listening.  I can
even see it catch traffic!  Woo hoo!

The problem is when I try to feed it a config file.  Even the most
simplest of configurations give me a PARSE error.  For example:

 

Create Windows 98
Annotate "Windows 98"
Set Windows 98 Personality "Windows 98"
BIND 1.1.1.1 Windows 98

I even double checked to make sure that "Windows 98" was defined in my
nmap.prints file.

Any idea where I can go from here?  I feel like I'm steps away from the
holy grail but the final inches are stretching into miles.


Regards,

Wren

Sr. Consultant
Prosum Technology Group