Need help to install and configure snort on 'TI Jacinto 7' ARM64 board

Hello,
We are planning to use snort as a IDS/IPS on Linux which is running on 'TDA4VM Jacinto 7' SoC board provided by Texas-Instrument.
My question is

1.       How we can install snort on that board? This is a ARM64 board. Can we build the snort source code for ARM and then install?

2.       How we will be able to configure snort for that board using Linux commands?

3.       What if we do not know the Ethernet interface name (like enp0s3) while configuring in that board?

Please help me to understand the points mentioned above.

Thanks & Regards,
Ayan Bandyopadhyay,
Wipro Technologies,
Mob - (+91) 9836654548

'The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments. WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email. www.wipro.com'

_______________________________________________
Snort-sigs mailing list
[email protected]
https://lists.snort.org/mailman/listinfo/snort-sigs

Please visit http://blog.snort.org for the latest news about Snort!

Please follow these rules: https://snort.org/faq/what-is-the-mailing-list-etiquette

Visit the Snort.org to subscribe to the official Snort ruleset, make sure to stay up to date to catch the most <a href=" https://snort.org/downloads/#rule-downloads">emerging threats</a>!