Re: explicit guide on how to setup a public node on Linux

Hi Lars,

Wednesday, November 12, 2003, 6:12:49 AM, you wrote:

LS> Hi!

LS> I tried to setup a public node for IIRC.
LS> But after set it up and starting I see no traffic on the PC nor a try
LS> for a connect, nor my node in the node.ref.
it can take up to 5 days to be an active node in the network. If you
can connect to IIP, that's the good part.
LS> Can anybody type a explicit list for setting up a node with isproxy 1.1.0 ?
That can be done.
LS> And why is in the listen.ref the IP = 127.0.0.1 ? shouldn there be my IP?
did you select to be a public node and put in your ip address?
listen.ref just binds your ports for listening on. And at this state
you are 127.0.0.1 to your computer.

LS> Cya
LS> Lars



-- 
Best regards,
 Lance James                          mailto:lance-I6tsvYnOiqa1tQ18MUY/[email protected]
Secure Science Corp.
www.securescience.net


_______________________________________________
iip-dev mailing list
[email protected]
http://lists.invisiblenet.net/mailman/listinfo/iip-dev