Re: 1.9.15 and cpqarray
Eric Shubert <[email protected]>
| Newsgroups | gmane.comp.security.ipcop.devel |
|---|---|
| Organization | Eric Shubert & Associates |
| Message-ID | <[email protected]> |
On 08/08/2010 02:02 AM, Olaf Westrik wrote:
> On 2010-08-04 20:20, Evil ZEN Scientist wrote:
>> All,
>>
>> Watching the release of new builds - did anything get updated regarding the
>> SCSI support?
>
> No.
>
>
> Olaf
>
> ------------------------------------------------------------------------------
I just installed 1.9.16 on VMware Server 2.0.2, and still no drive found
with LSILogic virtual SCSI. BusLogic virtual SCSI works fine, although
the BusLogic driver is intended for use with older Windows guests.
As mentioned previously, lspci shows:
00:10.0 SCSI storage controller: LSI Logic / Symbios Logic 53c1030 PCI-X
Fusion-MPT Dual Ultra320 SCSI (rev 01)
for this device with (Centos 5.4) kernel 2.6.18-164.11.1.el5.
According to http://communities.vmware.com/thread/201876, the
differences are minor and only apply during device driver loading, so
i/o speed should not be affected, although the VMware Best Practice
document suggests that the LSI Logic SCSI Controller is the better
performing one.
Note that BusLogic is usually associated with older Windows versions
(2k), and LSILogic with newer ones ('03,'08). I don't know how these
relate to Linux. VMware does recommend LSILogic for use with later
RedHat distros though.
I think it would be best if IPCop supported the LSILogic driver. Is
there anything I can do to help in this regard?
--
-Eric 'shubes'
------------------------------------------------------------------------------
Enable your software for Intel(R) Active Management Technology to meet the
growing manageability and security demands of your customers. Businesses
are taking advantage of Intel(R) vPro (TM) technology - will your software
be a part of the solution? Download the Intel(R) Manageability Checker
today! http://p.sf.net/sfu/intel-dev2devmar