Re: moving from 1 pc to another
Jim Stephens <[email protected]>
| Newsgroups | gmane.comp.security.ipcop.user |
|---|---|
| Message-ID | <[email protected]> |
On 10/26/2015 1:55 AM, Fabio wrote: > Il 26/10/15 08:27, [email protected] ha scritto: >> On Mon, October 26, 2015 2:00 am, scout_iosif wrote: >>> Can i just pull out the hard drive from the ipcop machine and move it to >>> another pc? >> I think that the network interface cards (nic) are going to be the >> problem; the sequence in which they are numbered in the new machine is not >> necessarily the sequence in which they are numered in the old machine. >> > You can just move the hdd to the new box, boot it, login from the > console and run "setup". In the network section you can then reassing > the correct cards to the interfaces. > This used to be a mess in ipcop 1.4.x, but the "netwrok setup" gui in > ipcop 2.x works fine. > > Fabio > The target PC will need to be compatible with the IPcop kernel you are using. You can also at root do a setup and reassign the cards with 1.4 a s well. I've had to do this a couple of times in the same PC and it should be okay to do so on the one you move it to. thanks Jim ------------------------------------------------------------------------------ _______________________________________________ IPCop-user mailing list [email protected] Manage your subscription or unsubscribe https://lists.sourceforge.net/lists/listinfo/ipcop-user