Re: moving from 1 pc to another
scout_iosif <[email protected]>
| Newsgroups | gmane.comp.security.ipcop.user |
|---|---|
| Message-ID | <[email protected]> |
On 10/27/2015 1:32 AM, Jim Stephens wrote: > On 10/26/2015 1:55 AM, Fabio wrote: >> Il 26/10/15 08:27, [email protected] ha scritto: >>> On Mon, October 26, 2015 2:00 am, scout_iosif wrote: >>>> Can i just pull out the hard drive from the ipcop machine and move it to >>>> another pc? >>> I think that the network interface cards (nic) are going to be the >>> problem; the sequence in which they are numbered in the new machine is not >>> necessarily the sequence in which they are numered in the old machine. >>> >> You can just move the hdd to the new box, boot it, login from the >> console and run "setup". In the network section you can then reassing >> the correct cards to the interfaces. >> This used to be a mess in ipcop 1.4.x, but the "netwrok setup" gui in >> ipcop 2.x works fine. >> >> Fabio >> > The target PC will need to be compatible with the IPcop kernel you are > using. You can also at root do a setup and reassign the cards with 1.4 > a s well. I've had to do this a couple of times in the same PC and it > should be okay to do so on the one you move it to. > > thanks > Jim > > > ------------------------------------------------------------------------------ > _______________________________________________ > IPCop-user mailing list > [email protected] > Manage your subscription or unsubscribe > https://lists.sourceforge.net/lists/listinfo/ipcop-user Thanks for your support! I will let you all know the results in a few days. Also i would like to ask if there is any addon for IPCOP 2.1.9 for a PBX server or a fork of the ASTERISK. Iosif ------------------------------------------------------------------------------ _______________________________________________ IPCop-user mailing list [email protected] Manage your subscription or unsubscribe https://lists.sourceforge.net/lists/listinfo/ipcop-user