Re: Please add better demarcation between hosts in nmap output

The output for a single host is everything from "Nmap scan report for"
until the next "Nmap scan report for" line. Adding blank lines could be
helpful, and when the scan is anything but -sn or -sL, there is a blank
line there. But there's also more output, so the blank line doesn't add
that much relative whitespace. With -sn, there are as few as 2 lines per
host (1 line for -sL), so adding a blank line is a 50% increase.

Note that when scanning your own subnet, your own IP address will be
deferred to scan separately, since it is not accessed via Ethernet/WiFi
like all the others. This is why it does not have a MAC address shown,
which could be the source of your confusion.

Dan

On Sat, Apr 22, 2017 at 6:16 PM, Dan Dascalescu <[email protected]>
wrote:

> When I run a scan against a range of hosts, it's hard to tell when one
> hosts begins if I look in the middle of the list - do hosts begin with the
> MAC address or with "Host is up" (which seems redundant - would nmap find
> hosts that are down?)
>
> Please see the attached screenshot or http://imgur.com/a/P9hH2.
>
>
>
> [image: Inline image 1]
>
> _______________________________________________
> Sent through the dev mailing list
> https://nmap.org/mailman/listinfo/dev
> Archived at http://seclists.org/nmap-dev/
>

_______________________________________________
Sent through the dev mailing list
https://nmap.org/mailman/listinfo/dev
Archived at http://seclists.org/nmap-dev/