RE: Not another NAT question.. Yes I'm Sorry

David I tested your suggestion and I have the same result. I went into the
Netgear Interface and unchecked IPSEC passthrough

 Enable VPN Passthrough (IPSec, PPTP, L2TP)

I then clicked apply and had one user connect and get into their terminal
emulator. Once they were in I had another use connect up. He got in. The
first users terminal emulator froze up and he could no longer do anything.

Did I miss something? NAT-T automatically turns on with the Netscreen
Client?

Thanks for your help

Joseph Brochu
Network Administrator
Transportation Resources, Inc.
978-422-7770  x303


  -----Original Message-----
  From: [email protected]
[mailto:[email protected]]On Behalf Of David
Klein
  Sent: Wednesday, July 07, 2004 5:35 PM
  To: Neo; [email protected]
  Subject: RE: [VPN] Not another NAT question.. Yes I'm Sorry


  Turn off IPsec pass-thru on the Netgear.  This will then trigger IPsec
NAT-T on the Netscreen VPN client.

  Dave Klein
  [email protected]



----------------------------------------------------------------------------
    From: [email protected]
[mailto:[email protected]] On Behalf Of Neo
    Sent: Wednesday, July 07, 2004 4:10 PM
    To: [email protected]
    Subject: [VPN] Not another NAT question.. Yes I'm Sorry


    I have a client using a Netgear FVS328 VPN Router.

    Runs NAT.

    The internal workstations use Netscreen Remote VPN client. I cannot get
more than one workstation connected at a time. If a user  is in and another
connects, the new user boots out the existing user and now that user is in.

    I am trying to understand somethings by reading but if someone could
help me out I would very much appreciate it.

    What I would like to know is, can this router or the VPN client somehow
get around this obvious limitation. NAT Traversal?

    If I have left out any needed info let me know.

_______________________________________________
VPN mailing list
[email protected]
http://lists.shmoo.com/mailman/listinfo/vpn