RE: Which command do I need

You need to list the ports individually, separated commas.  Below is the
relevant paragraph from the Zebedee manual.  The example given is the
Zebedee client's connection string; you would also need to use the part
starting with "somehost" in the Zebedee server's TARGET specification.  -
w.h.

You can also use a single Zebedee client to handle multiple simultaneous
tunnels to different target ports on the same remote host. In this case the
client and target port specifications are lists of ports. For example:

 zebedee 9001,9002,9003:somehost:daytime,telnet,ftp

This will tunnel traffic on the clientport 9001 to the daytime port on the
remote target system, traffic on 9002 to the telnet port and traffic on 9003
to the ftp port.

-----Original Message-----
From: zebedee-talk-admin-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org
[mailto:zebedee-talk-admin-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org] On Behalf Of Reg Burns
Sent: Saturday, March 13, 2004 3:12 PM
To: [email protected]
Subject: [Zebedee-talk] Which command do I need


I'm trying to do something like 5858,5959,5555:localhost:5800,5900,5500.
 
In other words take incoming encrypted & authenticated port 5858 and
redirect it plain vanilla to port 5800 all on localhost
 
The only commands I found were serverport, redirect, and target, but none of
them seem to do the above.  There's probably a combination that I'm to
stupid to figure out.



-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id70&alloc_id638&op=click