Re: iriver h10 install problem

----- Original Message ----- 
From: "Roger" <[email protected]>
To: <[email protected]>
Sent: Wednesday, June 25, 2014 4:47 PM
Subject: Re: iriver h10 install problem


> Just FYI.  Every time I would get such a message with any such destination
> device, the error was usually caused by the destination device being write
> protected or write permissions were not given.
>
> As such, make sure you perform these tasks as root or with system 
> administrator
> privileges, and double check write operations are really being performed 
> by
> also checking the time/date stamps on the destination files.
>
> So, just an FYI to make sure you're checking the time stamps!  So many 
> times,
> I've been caught by this simple error of not having written anything to 
> the
> device.
>
> If files are being written, then I'm stumped.
>

Hi Roger

I had just formatted <again> and used the iriver recovery tool. I tried *US* 
but it won't work, so I reverted to *Europe*. It now works OK as an *iriver* 
pl layer.
This is it's current state ATM.

There are four folders within.
*Properties* gives the date as 12/01/2004 12:54

Althouuugh I am showing *Hidden Files* I can see no files within.

As far as I am aware... I am Sole user and administrator. I don't know how 
to verify this though.

FWIW I only get the error message _after_ installing RB. I have to restore 
to the above condition before I can get it working, nut it's useless to be 
as I can't see it....which is why I need RB working.

Rog



-------------------------------------------------------------------
Unsubscribe: http://cool.haxx.se/cgi-bin/mailman/listinfo/rockbox
FAQ:         http://www.rockbox.org/twiki/bin/view/Main/GeneralFAQ
Etiquette:   http://www.rockbox.org/mail/etiquette.html