RE: Code V5R1M0 doesn't report events back after Win2k upgrade

>try STRCODE with *RESOLVE on your iSeries again 
>to see if it helps;


STRCODE SERVER(AS400COM) RMTLOCNAME(*RESOLVE)

No good.  If I don't specify the port, I get the following message:
Message ID . . . . . . :   EVF4001       
Message . . . . :   The port number specified is not correct.

Cause . . . . . :   The port value specified was 00.



STRCODE SERVER(AS400COM) RMTLOCNAME(*RESOLVE) PORT(4200)  

When I specify port 4200, I get an error window with the following:
Handshake information from the host server contains errors.
Connection request from 'COMMSOFT' has been ended by the daemon.

The unusual thing about this is that the iSeries I am running this from is
called AS400COM.


>DUMPOBJ STRCODE *USRSPC to SPL and check if the 
>IP address is correct for your workstation.

I did, and it was.  Just for grins, I deleted the user space and let STRCODE
re-create it.  No luck.

>Make sure that you apply TWEAK if you want the 
>completion message to be popped up.

Thanks, but there's no message to pop up; nothing to change focus to.
Thanks for trying Hak!  I appreciate it!
  --buck
_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l