Re: websphere dev studio 5.1

> I was just passing on the article to show
> that it is still possible to just use CODE/400
> and not the rest of the stuff you get in WDSC.

Yup - I understand.  I just wanted to relate that if one can't load WDSCi,
one can't use Code in WDSCi.

> "PII" - Is that right or a typo?  Man, that is an OLD processor.

That's right.  Pentuim II, 450 MHz.  And it runs WDT 5.1 Code/400 very
snappily.  Considering the anemic state of the economy, the company is
rather unwilling to spend $1000+ USD (PC + XP license fee) to enable me to
use a fraction of the capability (we're green screen only) of a slower
running, less functional (jLpex is still behind Code), web-centric
development tool like WDSCi.  And I honestly can't say I can blame the boss
this time.  I'm already using PC based Code/400, so I'm already pretty
productive - and we don't target V5R2 so I don't even notice the fact that
WDT 5.1 Code chokes on V5R2 BIFs.

> The current version of CODE/400 that comes with WDSC 5.0
> fully supports all the new RPG IV stuff in V5R2.

Very nice.  Thanks for that!
  --buck



_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l