CODE in WDSC 5.1.2 embedded SQL unknown

It appears that CODE in WDSC 5.1.2 cannot recognize embedded RPGLE SQL as
valid statements.
Whenever changing any source line with embedded SQL, we get the following:
RNF5001E Control-Level entry is not valid; defaults to previous control
level.
RNF5006E Not entry is neither N nor blank; defaults to blank.
RNF5007E Conditioning-Indicator entry is not valid; defaults to blanks.
RNF0289E Entry contains data that is not valid; only valid data is used.
RNF5010E Factor 1 entry is not blank for the specified operation; defaults
to blanks.

Fortunately, it compiles fine and the LPEX editor is okay.
I thought I would run it by this list before submitting this to IBM.
Anyone having this problem or heard of this?
Does anyone use CODE and embedded RPGLE SQL?  If so, and you are not on
WDSC 5.1.2 yet, you may want to watch this thread.

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l