Re: Is there a way to beam from emate to Mac via IR?
Grant Hutchinson <[email protected]>
| Newsgroups | gmane.comp.systems.newton.newtontalk |
|---|---|
| Message-ID | <[email protected]> |
>> On Jun 12, 2019, at 3:46 AM, Jon Glass <[email protected]> wrote: >> >> I used to beam notes from my Pismo, and packages to my Newt all the >> time from Pismo. In fact, I installed a mirror behind the Pismo so I >> could do the beaming without turning it around. I don't remember what >> software I used, though... It may have been third-party. That was >> looong ago > > On Jun 12, 2019, at 9:08 AM, Forrest <[email protected]> wrote: > > Yes; I now seem to recall a discussion here on NTLK some time ago—years—about that software. Gathered from the Newton FAQ ... It’s possible to use a terminal emulator and Steve Weyer’s Sloup to communicate via IrDA: https://communicrossings.com/html/newton/sloup.htm https://communicrossings.com/html/newton/sloup/connect.htm#IrDA Additional information: <https://web.archive.org/web/20110105021720/http://web.ukonline.co.uk:80/kieran.miller/newton/irda.html> Thomas Tempelmann’s Newton Data Browser also works on PPC Macs. http://www.tempel.org/newton/#DILplugin Note that I have not tried these solutions, so your mileage may vary. g. ---------------------------------------------------------------------- Grant Hutchinson NewtonTalk List Dad & Interweb Custodian ---------------------------------------------------------------------- http://newtontalk.net/ http://twitter.com/newtontalk