Re: [TME10}[ITM] omnibus SitForwarder

Hi Yoga,

Is your OMNIBUS running under PA ? that is mandatory if you want enable bi-directional (from Omnibus to ITM)

Also, if you execute the test.sh script under /op/IBM/SitForwarder/bin , what is the result? .. Connect SUF to your HUB TEMS?

About the connector in TEP, Do you have configured the TEPS the Omnibus connector tab with right user ?

Best regards 

Rafael Cerro Jimenez
[email protected]


On Friday, 23 November 2012 at 14:05, Yoganarasimha Iyengar wrote:

> Hi,
> This is issue related to SitForwarder ( NC 731FP05 on RHEL 6, Hub and TEP all on separate box) 
> 
> 1. I have setup ITM and Netcool event integration for bi-directional per steps outlined in IBM manual. 
> On HUB enabled EIF integration and on TEP forwarding situation to EIF.
> 
> 2. Inbound alerts reaching NC and can view them on NC Event console.
> 
> 3. The problem is, alerts updated on NC Event console not reaching TEP. I don't see any situation file under persistence directory except running .
> Also files under /tmp/itmsynch/logs don't give much info though I have setup the log for verbose.
> 
> 4. Another issue I notice is in TEP, Omniconnector(common event console) status is always non-operational. Not sure both issues inter related . Hub and TEP are on separate RHEL box.
> 
> 5. So far I have tried giving hostname and also IP in Omniconnector config but no luck
> 
> Thanks
> 
> Yoga Iyengar
> Desk: (301)-977-7884 Ext. 199
> Email: [email protected] (mailto:[email protected])
> 10480 Little Patuxent Parkway, Suite 1100
> Columbia, MD  21044
> 
> 
> _______________________________________________
> TME10 mailing list
> [email protected] (mailto:[email protected])
> Unsubscribe:[email protected] (mailto:[email protected])
> 
>

_______________________________________________
TME10 mailing list
[email protected]
Unsubscribe:[email protected]