Re: Page Margins - No effect at all

Thanks, is it possible that I specify the page size a4,b4 etc in the
JobControlcmd command ? If I change the page type, I get the required
result.

What parameter do I set in hylafax config or JobControlcmd file to set the
page size AFTER sendfax is executed. I don't seem to find the right
parameter.

The page type is ==> na-let , It is present within my pagesize database

North American Letter   NA-LET  10200   13200    9240    12400  472     345





-- 
Best Regards,
Rehman
Voice : +971-55-3157060
IM: [email protected]



On Fri, Jul 7, 2017 at 7:48 PM, Lee Howard <[email protected]> wrote:

> On 07/07/2017 06:46 AM, Rehman wrote:
>
>> No matter what Page Margins I am setting in the config file
>> (/var/spool/hylafax/etc/config), there seems to be NO impact whatsoever.
>> I am literally pulling my hair on this one
>>
>> PageMargins: l=0.25in,r=0.25in,t=0.00in,b=0.10in
>>
>> What could be I am doing wrong ? Please help
>>
>
> PageMargins is an option for textfmt and faxmail only.  See the end of
> 'man faxmail' and 'man textfmt' for options on a configuration file, but
> /var/spool/hylafax/etc/config is not one of them.  My advice would be to
> use /etc/hylafax/hyla.conf (if you installed via RPM or dnf/yum).
>
> Be aware, therefore, that PageMargins will only have affect on documents
> processed through faxmail or textfmt.
>
> If you're using sendfax to submit faxes then the page margins will largely
> be defined by the document, itself, that you submit.  (You have to set the
> margins within the document.)
>
> Thanks,
>
> Lee.
>