Re: Moving boxes with \step[...][...]

Hans Fredrik Nordhaug <[email protected]> schrieb:

> On Thu, Jun 03, 2004 at 05:52:00PM +0200, Frank K=FCster wrote:
>> Hi,
>>=20
>> I am trying to achieve the following effect:
>>=20
>> On one slide, under a common heading, I first want to display a simple
>> Scheme and an explaining Figure below. In the next step, the scheme is
>> replaced by a more complicated one which also takes more vertical
>> space. The Figure that explains Scheme 2 is different, but has exactly
>> the same dimensions, and should be displayed at the same place where
>> Figure 1 was. In a third step, a conclusion text appears below Scheme 2
>> and figure 2.
>>=20
>> The problem, as can be seen in the minimal example below, is that the
>> figures hop around: It is placed lower with the flatter Scheme 1.
>
> That is because you put Scheme 2 in a boxed step - so in step one you=20
> have Scheme 1 visible AND Scheme 2 boxed, hence taking more place than you
> want.

Ah, that's logical.

> Using the suggestion from Kockaert Pascal with a minipage (or some other =
box
> with a given height) for the schemes and *not* using bstep should work ni=
cely.

Thank you both very much!

Regards, Frank
--=20
Frank K=FCster, Biozentrum der Univ. Basel
Abt. Biophysikalische Chemie



-------------------------------------------------------
This SF.Net email is sponsored by the new InstallShield X.
From Windows to Linux, servers to mobile, InstallShield X is the one
installation-authoring solution that does it all. Learn more and
evaluate today! http://www.installshield.com/Dev2Dev/0504