RE: proxy server

 
Hmmm.  I am having two reactions to your note:

First, I'm surprised that this is working at all.

Second, I'm curious why you are getting that
particular symptom.

But mostly, I'm just surprised that it works at
all with a proxy server.  Is anyone here actually
using Vault regularly with a proxy server?  IIRC,
this is not something we would consider a
"supported" configuration.

Anyway, as to your actual problem:  I don't suppose
there is something in your proxy server which is
configured to timeout sockets after one minute?  ;-)

AFIAK, there is no timeout in Vault which is 60
seconds long.

--
Eric Sink
Software Craftsman
http://software.ericsink.com/
 
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Brett A Hoover
Sent: Tuesday, January 06, 2004 4:45 PM
To: [email protected]
Subject: [vault-list] proxy server

I have Vault set up on a port other than 80.  Everything is working 
correctly except when I'm on site at a vendor where they use a proxy 
server. 

In order to get Vault to function correctly, I need to start up Vault, 
then fire up IE (with proxy enabled) and hit  
http://myurl:port/VaultService/VaultService.asmx -- which loads fine.  
Then I am able to login to Vault.  Without doing this, Vault refuses the 
connection.

Additionally, after a minute, any additional request to Vault gives me 
the error message  that Vault couldn't perform the action.  My 
connection to the server may have timed out.  I go to browser, refresh 
the page, then retry the operation and everything works fine.

Despite it working, it is very annoying to have to refresh a web page 
before performing a Vault operation.  And note, that the time out can be 
less than a minute.

Any ideas/suggestions would be greatly appreciated.

Thanks

Brett

_______________________________________________
vault-list mailing list
[email protected]
http://lists.sourcegear.com/cgi-bin/mailman/listinfo/vault-list