Re: Problem Converting Symbols

I actually was able to get past this by changing the options file to use
UnambiguousUsageRule()

Now I will go in ans spot check the tags as compared to CVS to see how they
look.

Mark




Mark-E wrote:
> 
> I am running CVS2SVN and seeing an issue converting tags and branches. 
> 
> When I run CVS2SVN without the options file on a project, tags and
> branches get converted properly however when I use the options file
> downloaded from the CVS2SVN project page (2.3.0), I get an error in Pass 3
> (CollateSymbolsPass) where it says it is not clear on how symbols should
> be converted. 
> 
> I was just wondering what the default value is (when running without the
> options file) since it works ok when not using the options file.
> 
> The options file I am using has the following set:
> 
>     # Convert ambiguous symbols based on whether they were used more
>     # often as branches or as tags:
>     HeuristicStrategyRule(),
> 
> To test, I tried using the AllTagRule() instead but it did not seem to
> make a difference.
> 
> Could it be I am changing the wrong variable? 
> 
> Thanks,
> Mark
> 
> 

-- 
View this message in context: http://www.nabble.com/Problem-Converting-Symbols-tp25443758p25460973.html
Sent from the cvs2svn - users mailing list archive at Nabble.com.

------------------------------------------------------
http://cvs2svn.tigris.org/ds/viewMessage.do?dsForumId=1670&dsMessageId=2395232

To unsubscribe from this discussion, e-mail: [[email protected]].